The Iteaduino is an Arduino compatible controller board based on Arduino Uno and is 100% compatible with existing programs and shields. This microcontroller provides extra features yet consumes only about half the power as original Arduino boards.
A DC-DC power supply design provides higher conversion efficiency than the original Arduino boards and can cut power consumption in half. This board can work at both 5V and 3.3V levels at the flip of a switch so you can use Iteaduino to connect with 3.3V level devices directly.
The Iteaduino microcontoller board has all of the pins broken out. Handy 3 pin headers are available for most pins. Each 3 pin set includes the digital or analog I/O signal in addition to VCC and GND, greatly simplifying connections to sensors, servos and other modules. Both the I2C and UART pins are also exposed.
Features
Note: the Iteaduino uses the FTDI USB-to-serial driver chip and Duemilanove bootloader instead of the UNO bootloader. Please choose the "Arduino Duemilanove or Nano w/ ATmega328" under the "Tools"->"Board" menu when connecting via the Arduino IDE. No special drivers are required.
Microcontroller | |
Processor | ATmega328p |
Architecture | AVR |
Clock Speed | 16 MHz |
Data Bits | 8 |
RAM | 2 KB |
FLASH | 32 KB |
EEPROM | 1 KB |
Timers | 3 |
External IRQs | 2 |
PWM Channels | 6 |
Available Inputs and Outputs | |
Digital GPIOs | 14 |
Analog Inputs | 6 |
I2C Ports | 1 |
SPI Ports | 1 |
UART Ports | 1 |
Microcontroller Features | |
Reset Button | Yes |
ICSP Connector | Yes |
Programming Port | USB Type Mini B |
Requires External Programmer | No |
UI Features | |
User LEDs | 1 |
Power Supply and Consumption | |
Operating Voltage | 5 V |
DC Current per I/O Pin | 40 mA |
Power LED Indicator | Yes |
Power Supply Voltage | 7-12 V |
Power Connector | Jack: 2.1mm ID 5.5mm OD Center Positive |
Dimensions | |
Length | 69 mm |
Width | 57 mm |
Weight | 45 g |