L298N Dual H-Bridge Motor Driver

The L298N Dual H-Bridge Motor Driver is a low cost motor driver board that can be used to drive two robot motors. It uses the popular L298N Dual H-Bridge Motor Driver chip and is powerful enough to drive motors from 5-35 Volts at up to 2 Amps per channel. The flexible digital input controls allow each motor to be fully independent with complete control over speed direction and braking action.

This board provides a handy 5V regulator that can be used to power other circuitry such as your robots microcontroller. Its modular design is easily adapted to a wide variety of robot controllers including the popular Arduino family.

See the Articles tab for more information.

Features

• Popular L298N Dual H-Bridge Motor Driver chip
• Drivers motors from 5-35V at up to 2A per channel
• Provides 4 LEDs that reflect the state of the control logic
• Independent direction, speed and braking for each motor
• Screw terminals for easy connections to motors and power
• Includes a heavy duty heat sink for maximum performance
• Easy to interface with with most robot controllers
• Supports current sensing
• Handy power LED

Specifications

• Input voltage: 5-35V
• Output current: 2A per channel
• Control logic: standard 5V TTL
• Power consumption: 36ma for logic
• Size: 55mm * 60mm * 30mm
• Weight: 33g

Related Articles

• How to use the L298N Dual H-Bridge Motor Driver

Motor Driver Features
Motor Driver	L298N
Motor Voltage	5-35 V
Motor Channels	2
Continuous Current per Channel	1 A
Peak Current per Channel	2 A
Motor Connectors	Screw Terminals
Power Supply and Consumption
Operating Voltage	5 V
Power Supply Voltage	5 V or 7-35 V
Power Consumption	36 mA (logic)
Power Connector	Pins (5 V) or Screw Terminals (7-35 V)
Dimensions
Size	49 x 55 x 33 mm
Weight	33 g

Write a review

Your Name:


Your Review: Note: HTML is not translated!

Rating: Bad           Good

Enter the code in the box below: